I. Post-Use Daily Procedures
- Cleaning Heating Molds
- Wait until temperature drops below 80°C, wipe off plastic residues with pure cotton cloth
(Strictly prohibit metal brushes or chemical solvents) - Remove stubborn carbon deposits with wooden scrapers gently to avoid damaging PTFE coating
- Wait until temperature drops below 80°C, wipe off plastic residues with pure cotton cloth
- Inspecting Power Cords & Plugs
- Check for exposed copper wires, scorch marks, or deformation
- Immediately stop use and replace with genuine parts if abnormalities are found
II. Periodic Component Maintenance
| Component | Maintenance Interval | Key Procedures |
|---|---|---|
| Heating Molds | Every 3 months | Check coating integrity after disassembly; replace if peeling area >5mm² |
| Temp Sensors | Every 6 months | Clean probes with anhydrous alcohol; recalibrate (return if error >±3°C) |
| Fan Filters | Monthly | Remove dust with vacuum; wash with water and dry thoroughly (clogging causes overheating) |
III. Long-Term Storage Protocol
- Apply high-temperature anti-rust grease on mold surfaces, wrap with grease-proof paper
- Store in environment with humidity <60%, avoid temperatures below -15°C
*Notes:
- PTFE = Polytetrafluoroethylene
- All measurements strictly follow original specifications*
